APCDiscontinued UPS

APC Smart-UPS 1500VA tower (SMT1500)

The official replacement cartridge for the North American SMT1500 tower is RBC7, a 24 V, 17 Ah sealed lead-acid cartridge with a 2-year repair-or-replace warranty.

Status. The SMT1500 was discontinued on June 30, 2024. Schneider Electric lists end of standard service as June 30, 2030. The official replacement model is the SMT1500C.

Official replacement cartridge

RBC7

Official SKURBC7
Voltage24 V
Capacity17 Ah
TypeSealed lead-acid
Cartridge quantity1
Cartridge warranty2-year repair or replace
AssemblyFully assembled and ready for use

Official RBC7 product page

UPS specifications (from the official datasheet or product page)

Family / product nameAPC Smart-UPS 1500VA tower (SMT1500)
VA rating1440 VA
Watt rating1000 W
Rating noteSchneider’s datasheet rates this unit at 1440 VA / 1000 W, even though the marketing name is “1500VA.”
TopologyLine interactive
WaveformSine wave
Input voltage120 V
Form factorTower
Outlets8 × NEMA 5-15R
Transfer time4 ms typical, 8 ms maximum
Typical recharge time3 hours (typical)
Typical battery life3–5 years
Official RBC quantity1
User-replaceable batteryYes (one RBC)
UPS warranty (as published)36 months (UPS), 24 months (battery supplied with the UPS)
Equipment protection policyLifetime: $150,000

Related models

How to replace the battery

Schneider Electric tells you to use only a genuine APC Replacement Battery Cartridge and to follow the instructions packed with the RBC. Confirm the model number on the sticker on the bottom or rear of the UPS — not from the front bezel, and not from the old cartridge alone.

  1. Read the official SMT1500 user guide and the instruction sheet that ships with RBC7 before you start.
  2. Confirm the UPS label says SMT1500 (or, if you have a later unit, SMT1500C / SMT1500CUS / SMT1500CNC). Other 1500 VA Smart-UPS models can use a different cartridge.
  3. If you are not sure the unit supports battery replacement while powered, shut the UPS down and unplug it from the wall before opening the battery compartment.
  4. Install the complete RBC7 cartridge as a unit. Do not mix an old module with a new one.
  5. After installation, allow the UPS to recharge (the official typical recharge time is 3 hours) and run a battery self-test from the LCD if the unit offers one.
  6. Recycle the used cartridge. Schneider’s RBC pages note that genuine cartridges support APC-authorized recycling.

These are orientation steps, not a substitute for the manufacturer’s instruction sheet. Lead-acid UPS batteries can present electrical and chemical hazards.

Warranty considerations

Genuine vs third-party packs. This guide lists only the official manufacturer cartridge. Third-party kits are widely sold, but this site does not verify their dimensions, runtime, or safety against the OEM specification. Schneider Electric’s FAQ on genuine APC RBCs states that a non-APC battery may result in lower runtime, damage the UPS, create hazardous conditions, or void safety certifications, and that it will void APC’s Equipment Protection Policy. If you still consider an aftermarket pack, treat voltage, capacity, and physical fit as necessary starting points — not as proof of compatibility — and expect warranty terms to change.

When to replace the whole UPS instead

Where to buy (affiliate placeholders)

These are ordinary search links, not tracked affiliate tags. When a program is joined, replace the href and keep the data-affiliate attribute.

Search Amazon for APC RBC7 Affiliate placeholderSearch eBay for APC RBC7 replacement battery Affiliate placeholder

Affiliate disclosure

FAQ

Is the official battery for an SMT1500 really RBC7?

Yes. The official SMT1500 product datasheet lists the replacement battery as RBC7. The dedicated RBC7 product page describes it as a 24 V, 17 Ah lead-acid cartridge with a 2-year repair-or-replace warranty.

Does the newer SMT1500C use the same cartridge?

The Smart-UPS C-series user manual lists RBC7 for SMT1500C, SMT1500CUS, and SMT1500CNC. Still check the label on your specific unit, because regional variants (for example the Japanese SMT1500J) use a different kit.

Why does a “1500VA” unit show 1440 VA on the datasheet?

Schneider’s SMT1500 datasheet rates the UPS at 1440 VA and 1000 W. Use those figures when you size the load, not the marketing name.

Sources